Skip to content

Complimentary delivery on orders over ₹15,000 · Cash on delivery across India

Buying guide

How to Choose a Kitchen Chimney in India

A kitchen chimney is not a single-size purchase. The right model depends on the width of your hob, how much frying and tempering you do, the filter you are willing to clean and the duct route your kitchen allows. This guide walks through each decision in the order that matters.

By ODIN Care · Updated 17 Nov 2026 · 8 min read

Start with the width of your hob

The hood should be at least as wide as the hob beneath it. A hood that is narrower than the burners lets smoke curl around the edges instead of capturing it. For a standard four-burner hob, 60 cm is the compact choice, 75 cm gives more margin and 90 cm suits wider hobs and open kitchen runs.

If your hob sits close to a side wall, check that the hood body clears the wall and that the canopy still covers every burner. Our 60 cm kitchens collection covers the compact end of the range.

  • 60 cm hood: small to medium hobs and tight kitchen runs
  • 75 cm hood: four-burner hobs with a little more working room
  • 90 cm hood: wide hobs, open kitchens and heavier cooking
  • When in doubt, go wider rather than narrower

Work out the extraction you need

Extraction is measured in cubic metres per hour (m³/hr). A higher figure moves more air, but the right number depends on cooking style, kitchen size and whether the kitchen is open to the rest of the home. Light boiling and steaming needs less than frequent deep-frying and high-heat tempering.

ODIN models are rated between 1,200 and 1,800 m³/hr, with 1,600 m³/hr across much of the range. For an open kitchen or a household that cooks Indian food daily, aim for the upper end rather than the minimum.

  • Light cooking: around 1,000–1,200 m³/hr
  • Everyday Indian cooking: around 1,200–1,600 m³/hr
  • Heavy frying and open kitchens: 1,600 m³/hr or more
  • A blocked or undersized duct can cancel out a high rating

Choose a filter you will actually clean

There are two main approaches in the ODIN range. Baffle filters use angled metal plates to trap grease; they are washable, serviceable and comfortable with high-heat cooking. Filterless systems use centrifugal separation and an oil collector, so there is no mesh to scrub and airflow stays consistent between cleans.

Both work. The better choice is the one that fits your routine. If you prefer a familiar metal filter that goes in the sink, look at baffle filter range hoods. If you want fewer removable parts and a quicker wipe-down, start with filterless range hoods.

  • Baffle: washable metal plates, strong with high-heat cooking
  • Filterless: centrifugal separation plus an oil collector, no mesh
  • Mesh filters: common on budget models, need frequent degreasing
  • Check how easily the oil collector can be removed

Decide how much control you want

Controls are a daily-use detail. Motion-sensor panels let you start the fan with a wave, which keeps greasy fingers off the glass. Touch panels are direct and simple. Push-button controls are the most straightforward to live with and repair.

Auto-clean cycles are useful in heavy-use kitchens: the hood heats the housing to loosen oil, which then drains into the collector. Look at smart auto-clean models if cleaning the motor housing is the part you want to avoid.

Listen for the noise figure

A chimney runs while you cook, so noise matters as much as suction. ODIN models are rated at 52–56 dB. Higher extraction usually brings more noise, which is why a larger hood running at a lower speed can be quieter than a small hood running flat out.

If your kitchen opens into a living or dining area, prioritise a model with a comfortable low speed and place the duct route away from the seating side.

Plan the duct before you buy

Ducted installation always outperforms recirculation when a route is available. Use a smooth, rigid duct of the size specified in the manual, keep the run as short as possible and avoid unnecessary bends. Each bend adds resistance and reduces real-world extraction.

The duct should terminate outside with a flap or cowl that keeps rain and birds out. If ducting is genuinely impossible, a recirculating setup can be used, but it filters and returns air rather than removing moisture and heat.

  • Measure the route from hood to outside wall before ordering
  • Prefer rigid duct over flexible pipe
  • Keep bends to a minimum and seal every joint
  • Confirm the duct diameter required for the model

A simple checklist before you order

Write down the hob width, the cooking style, the duct route and the position of the nearest power point. Then compare models on width, extraction, filter type and controls — in that order. If two models are close, choose the one with the simpler cleaning routine.

Delivery, returns and warranty terms are set out in our Delivery policy, Returns policy and Warranty policy.

  • Hood at least as wide as the hob
  • Extraction matched to cooking style and kitchen size
  • Filter type matched to the cleaning you will do
  • Duct route and power point confirmed
  • Installation height checked against the manual

Common questions

What size chimney do I need for a 60 cm hob?
A 60 cm chimney is the minimum match for a 60 cm hob. If the kitchen is open or you cook heavily, a 75 cm or 90 cm hood gives more capture area and lets you run at a lower, quieter speed.
Is 1,200 m³/hr enough for Indian cooking?
For light everyday cooking it can be sufficient. For frequent frying, tempering and high-heat cooking, 1,600 m³/hr or more is a safer target, provided the duct is correctly sized and the route is short.
Should I choose baffle or filterless?
Choose baffle if you prefer a washable metal filter and cook at high heat. Choose filterless if you want no mesh, a removable oil collector and quicker routine cleaning. Both are effective when maintained.
Can a chimney be installed without ducting?
Yes, in recirculating mode, but it will not remove heat and moisture from the kitchen. Ducted installation is preferable whenever an outside route is available.
How high should a kitchen chimney be installed?
Most installations sit 65–75 cm above the hob. Always follow the installation manual for the specific model, as canopy shape and hob type can change the requirement.

Explore the range