Installation guide
Kitchen Chimney Installation and Care
A chimney performs best when the installation is planned before the unit is mounted. Height, duct route, duct diameter and power access all affect extraction and noise. This guide covers the essentials and the routine that keeps the hood working.
By ODIN Care · Updated 17 Nov 2026 · 7 min read
Before installation
Confirm the hood width against the hob, check the clearance to side walls and decide where the duct will leave the kitchen. The power point should be reachable without stretching the cord and should not sit directly behind the flue.
If you are renovating, run the duct and electrical point before the ceiling or wall finishes are closed. Retrofitting a duct route later is usually the most expensive part of the job.
- Hood at least as wide as the hob
- Duct route measured to an outside wall
- Power point within reach, away from the flue
- Wall or ceiling strong enough for the mounted weight
Height and ducting
Most installations place the hood 65–75 cm above the hob. Follow the manual for your model, because canopy shape and hob type can change the requirement. Too low can be uncomfortable and unsafe; too high reduces capture.
Use the duct diameter specified for the model, keep the run short and avoid unnecessary bends. Seal joints and fit an external flap or cowl. A smooth, rigid duct with a clean exit will outperform a longer, flexible run.
The first use
Remove any protective film, check that the oil collector and filters are seated correctly and run the fan through each speed before cooking. Confirm that air is flowing outside rather than leaking back into the kitchen.
Keep the manual and invoice together. Warranty terms and the component-specific period are stated in the documentation supplied with the product.
A simple cleaning routine
Grease is easier to remove before it hardens. Wipe the canopy after heavy cooking, wash or empty the oil collector regularly and clean the filter or separation housing according to the manual. Use a non-abrasive cleaner and avoid flooding electrical parts.
- After cooking: wipe the canopy and controls
- Weekly or as needed: clean the oil collector or baffle filter
- Monthly: check the duct outlet and surrounding surfaces
- Periodically: inspect the power cord and mounting fixings
If extraction feels weak
Check the filter or oil collector first, then the duct outlet. A blocked outlet, a crushed flexible duct or a closed external flap will reduce airflow even when the motor is running normally. Confirm the fan is on the intended speed.
If the issue continues, contact support with the model, order number and a short description. Delivery, returns and warranty terms are in our Delivery policy, Returns policy and Warranty policy.
Common questions
- What is the correct installation height for a chimney?
- Most kitchen chimneys are installed 65–75 cm above the hob. Always follow the manual for the specific model and check clearance around the canopy.
- What duct diameter should I use?
- Use the diameter specified in the model's manual. A smaller duct than specified restricts airflow and increases noise.
- How often should I clean the oil collector?
- Check it weekly in a kitchen that cooks daily and empty or wash it before it fills. Heavy frying will need more frequent attention.
- Why is my chimney noisy?
- Noise can come from a high fan speed, a loose mounting, a duct that is too small or a duct route with sharp bends. Check the installation and duct before assuming a motor fault.
- Can I install the chimney myself?
- Installation involves wall mounting, electrical connection and ducting. Use a qualified installer and follow the manual, especially for height, clearance and duct sealing.